Launch UI
This guide outlines the various buying and launching modes available in the application, each designed for different trading strategies and launch scenarios.
1. SET BUY AMOUNTS
Configuration mode that:
Sets the buy amount for each wallet
Applies to all trading modes
Must be configured before using other features
2. LAUNCH PUMP
Block 0 bundle strategy:
Creates new token
Executes bundled buys from all sub wallets simultaneously
Provides maximum coordination for initial liquidity
"Frontrun/Mev/Sniper" protected no one can buy before your wallets
3. MAGIC MODE
⚠️ EXPERIMENTAL MODE Advanced bundled snipe strategy:
Launches token
Attempts post-creation snipe with all sub wallets
Warning: Can be front-run by other snipers
4. LAUNCH + SNIPE V2
⚠️ EXPERIMENTAL MODE Enhanced launch strategy:
Launches token and buys with dev wallet in same transaction
Monitors for creation TX confirmation
Sends multiple simultaneous snipe bundles with sub wallets
Buys not flagged as "Rats/Insiders"
Note: Buys may land at different times or potentially fail
Warning: Can be front-run by other snipers
5. SNIPE ONLY
Targeted buying mode:
Bundles buys from all sub wallets
Optional inclusion/exclusion of dev wallet
Works with PumpFun non-migrated tokens only
Requires manual token address input
6. STAGGER BUY
Distributed buying strategy:
Option 1: Launch token + staggered buying
Option 2: Manual CA input + staggered buying
Configurable min/max delays between buys
Not flagged as RAT/INSIDER
Note: No protection from intervening trades (snipers/"frontrunners")
7. BUNDLE + STAGGER
Hybrid protection strategy:
Bundles dev buy & first sub wallet with launch
Provides initial sniper protection
Triggers staggered buys for remaining sub wallets
Uses configured min:max delay values
8. SNIPER DUMP
Anti-sniper strategy:
Launches token with dev wallet buy only
Monitors buy volume
Triggers instant 100% dump when volume reaches minSolBuy
Ideal for countering unwanted sniping activity
9. SIMULATE BUY VALUES
Analysis tool that displays:
Estimated token acquisition per wallet
Supply percentage per wallet
Cost estimates with 15% slippage
Total aggregated values
Helps in pre-trade planning
10. CLONE METADATA
Utility function for PF tokens:
Clones token metadata
Copies associated images
Enables custom token launches
Works exclusively with PF tokens
Important Notes
Configure buy amounts before using any mode
Experimental modes carry higher risks
Monitor market conditions during staggered buys
Keep sufficient funds for all planned transactions
Consider slippage in cost calculations
Some modes are PumpFun (PF) specific
Last updated